Element

10 articles

Element and Fusion Module ID information

Scope. This document applies to both Fusion and Element Console and Accessory modules. Description. There are several type of modules available for Fusion and Element consoles. When looking at the mo…

Updated 1 month ago by Bryan Jones

Capturing Element or Fusion Console Modules

Scope. This article describes the process for capturing the Element and Fusion Console Modules upon initial setup. Description. Upon initial setup, the console over-bridge will display " INACTIVE " o…

Updated 3 months ago by John (JP) Powell

Removing a CAN Bus distribution board from an Element console

Removing right-hand molding and side panels to remove the CanBus "distro" board.

Updated 3 months ago by Bryan Jones

Why are the GPIO status indicators not working on my Element power supply?

Scope. This document applies specifically to the power supply and GPIO unit used with Axia Element consoles and discusses the GPIO status indicators on the GPIO page. These units cary Axia part numbe…

Updated 3 months ago by Bryan Jones

Cleaning and Lubricating Element (and Fusion) Faders

This article applies to Element and Fusion consoles with non-motorized and motorized faders.

Updated 6 months ago by John (JP) Powell

I Have an Up Arrow on My Element/Fusion Display Channel

A document on how to remove the up arrow on your Element or Fusion.

Updated 6 months ago by Johnny Goldsmith

Changing Element or Fusion On/Off Switches

A document on how to remove and replace the ON and OFF buttons in your Fusion or Element modules.

Updated 6 months ago by Johnny Goldsmith

Over-Bridge Shows "X" Instead of Channel Position Number

Scope. This article is meant to apply to Element, but the info here can be applied to any console engine, really. Description. Sometimes loading a source to an input channel on the console will resul…

Updated 6 months ago by John (JP) Powell

Viewing and Changing the Element GPIO Power Supply IP Address

Scope. This document explains how to view and change the IP address of the Element GPIO Power Supply from the Element Console. Description. When the Element GPIO Power Supply is reset to factory defa…

Updated 6 months ago by John (JP) Powell

Element GPIO PSU Battery Replacement

Even though all bios settings are shown here for reference, only a changes are required. Those are noted in RED. To replace the CMOS battery [CR2032 (+3 Volts) BOTH BOARD TYPES] in an Axia GPIO/PS un…

Updated 9 months ago by Bryan Jones

TelosHelp (opens in a new tab)

Powered by HelpDocs (opens in a new tab)