MPX Node

11 articles

uMPX "Limit Rate Below" Setting

An explanation of the "Limit Rate Below" setting in the MPX Node Encoder.

Updated 2 weeks ago by Mark Manolio

Configuring MPX Nodes for redundant streams

Version 1.3.35 of the Omnia MPX Node adds redundant streaming capability.

Updated 2 weeks ago by Jake Alderman

Rack mounting an MPX node

All MPX Nodes come standard with a rack mount kit. Mounting options are the same as Axia xNodes since the chassis is the same. One unit can be be mounted in a single rack space, or two can be mounted…

Updated 2 weeks ago by Bryan Jones

MPX Node release notes and update instructions

Information on Version 1.3.35.

Updated 2 weeks ago by Bryan Jones

MPX Node Licensing FAQ

Scope. An explanation of all of the licensing options for the MPX Node and when and if they are needed. Question. What license options must I purchase for my MPX Nodes to send the same MPX stream to…

Updated 2 months ago by Mark Manolio

Optimizing Modulation and Minimizing Overshoots With MPX Node Pair

Scope. Optimizing an MPX Node Encoder / Decoder pair for tightly-controlled modulation with minimal overshoots and distortion. Description. The MPX Node uses the revolutionary μMPX codec to send comp…

Updated 2 months ago by Mark Manolio

Ensuring RDS Bit Errors Do Not Occur

Scope. Making sure bit errors do not occur when using MPX Nodes to pass RDS along with the main composite MPX signal. Description. A customer who was testing an Omnia Volt FM with an external RDS gen…

Updated 3 months ago by Mark Manolio

How to configure error correction and calculate bandwidth on the MPX Node

Scope: This document covers how to configure error correction on the Omnia MPX Node Encoder, and calculate the total amount of bandwidth required to use it. Configure Error Correction. How to set err…

Updated 5 months ago by Jake Alderman

Configuring an MPX Node Decoder to receive multicast

SCOPE. Version 1.3.35 of the Omnia MPX Node Decoder added the ability to receive a multicast stream. While the encoder, and network also must support multicast, this document assumes this these condi…

Updated 11 months ago by Jake Alderman

Configuring the Encoder MPX Node to send Multicast

SCOPE. Version 1.3.35 of the Omnia MPX Node encoder added the ability to send a multicast stream. While the decoder, and network also must support multicast, this document assumes this these conditio…

Updated 11 months ago by Jake Alderman

Enabling licensed features in MPX Node

SCOPE. Version 1.3.35 of Omnia MPX Node software created the ability to receive a multicast stream on a Decoder, and enable additional streams on an Encoder. Both of these features require add-on lic…

Updated 11 months ago by Jake Alderman

TelosHelp (opens in a new tab)

Powered by HelpDocs (opens in a new tab)