All Categories > Axia > Fusion
13 articles
This article applies to the Fusion and Element console systems using the Studio Engine or Powerstation platforms running version 3 or higher.
Updated 9 hours ago by John (JP) Powell
Scope. This document covers both Element and Fusion console, where you use the number pad on the console Master module for dialing. Description. When you dial a telephone number from an Element or Fu…
Updated 1 week ago by Bryan Jones
The procedure for cleaning and lubricating Fusion faders is identical to the Element procedure, which can be found at the link provided here.
Updated 1 month ago by John (JP) Powell
This article describes how to remove or replace a Fusion console module. This can also be applied to Element as the hardware is very similar.
This article discusses the removal / replacement of a Fusion Overbridge Module only. This procedure does not apply to Element.
Scope. This document covers the different operating modes of User Modules mounted in a Fusion or Element console. There are two basic modules shown here. There is an LCD version that can display text…
Updated 1 month ago by Bryan Jones
Scope. The intent of this document is to cover the configuration of an Element or Fusion to control a Telos Hx6 or iQ6 System from the input channel without a 2-Fader Call Control Module. It presumes…
Updated 2 months ago by John (JP) Powell
SCOPE. You can add virtual faders to most Axia consoles. This document covers the process of adding virtual faders to Fusion consoles or to Element consoles with Power Station, where the software ver…
Updated 2 months ago by Bryan Jones
Scope. The intent of this document is to cover the configuration of an Element or Fusion 2-fader call control module to control a Telos VX System. It presumes that the VX system has been configured,…
Updated 3 months ago by John (JP) Powell
Scope. The intent of this document is to cover the configuration of an Element or Fusion 2-fader call control module to control a Legacy Telos Nx or TWO-x-12 Hybrid System. It presumes that the Nx12…
Scope. The intent of this document is to cover the configuration of an Element or Fusion 2-fader call control module to control a Telos Hx6 or iQ6 Hybrid System. It presumes that the hybrid system ha…
Updated 4 months ago by John (JP) Powell
These are several steps needed to enable the AUX busses on a Fusion or Element console. They are detailed here. ENABLE THE SOURES. From the main web page of your console, click on Prog & Mon Out unde…
Updated 4 months ago by Bryan Jones
SCOPE. This document covers the set up of the Fusion fader accessory module with part number 2001-00419-000 DESCRIPTION. We will cover the configuration of the Fusion fader accessory module. We assum…
Powered by HelpDocs
