Omnia VOLT®

8 articles

Settings for NRSC Pre-Emphasis in Volt AM

How to set the Volt AM up for the "actual" NRSC Pre-emphasis curve.

Updated 6 days ago by Mark Manolio

What ports are needed to access an Omnia VOLT® Remotely

Ports needed to access an Omnia Volt remotely.

Updated 2 months ago by Mark Manolio

Password reset for Omnia ONE and VOLT audio processors

This procedure will reset the OmniaONE’s security password to the factory default: “omnia” (all lower case). Use this when the front panel is locked and the password is unknown. Unplug (remove power…

Updated 3 months ago by Bryan Jones

Using Physical GPI to Select the Primary Input Source

Scope. How to use the rear panel GPI "Interface" connector to change the Primary Input Source. Note: This also applies to the Omnia One. Description. Using external dry contact closures, you can use…

Updated 3 months ago by Mark Manolio

Setup of the Volt FM for Mono

Scope. How to setup the Volt FM for mono transmission. Description. There are several options available in the Volt for setting it to mono. Please see below for the details. Setup. You can feed mono…

Updated 4 months ago by Mark Manolio

Setting The Input Failover Time to 60 Seconds

Scope. Instructions to extend the Input Failover Time setting to 60 Seconds. Description. The Volt manual states that the Failover Time should be adjustable from 0 to 60 seconds however the GUI will…

Updated 6 months ago by Mark Manolio

Omnia VOLT Software update procedure

Scope. This document covers the steps necessary to update the software version on your Omnia VOLT. Note that document is not version specific and may reference versions other than what you might have…

Updated 11 months ago by Bryan Jones

Converting Your Omnia Volt To Another Style

Scope. This document applies to changing the DSP Core style of the Omnia VOLT. Description. The hardware of all Omnia VOLT units is the same. Any Omnia VOLT can run any of the four available DSP Core…

Updated 1 year ago by Mark Manolio

TelosHelp (opens in a new tab)

Powered by HelpDocs (opens in a new tab)